Arrow cutter

[jethrobuddy]

Does anyone have plans for an arrow cut off set up?

[WOOKIE]

Here are some plans right off of our site!

http://www.bowzone.ca/modules.php?op=modload&name=News&file=article&sid= 4

[scooter]

Does anyone have plans for an arrow cut off set up?

How's the arrow saw project coming along?

[jethrobuddy]

I just printed the destructions off of the site as we speak. I think that it should go pretty good. I built a bow press from the site, I cost me about $25.00. I don't think you would be able to tell this one from a store bought one if that exists. I still might have some questions for the building of the saw. I have to look over the plans and start to make it. I will keep you informed.

[jethrobuddy]

I do have questions about the arrow cutter. How long is the angle iron? The socket head cap screw(allen head bolt)...does a guy drill into the socket for the motor shaft, and then through the side of the head for the setscrew? I have not a clue how these things work,so bear with the dumb questions. Is there a better picture somewheres for the far end of the cutter setup?

[pascallee]

I was just looking for plans of a home made arrow cutter and fell here but the link to the plans in this thread does not work.

[Mikey]

I was just looking for plans of a home made arrow cutter and fell here but the link to the plans in this thread does not work.

Yes the main site is down for a total re-vamping ...of all our Info and reveiws and tips ..etc.... the last server just couldnt hold it all ...some other reasons that is just geek talk ..... From what I understand the new site is about done and just starting to be put through the paces as I type this ......

[pascallee]

Thanks for the info.