String Loops

[sledder]

Howdy all,

I have been shooting with the aid of a string loop and mechainical release. I realize that without the loop I can gain an extra inch of draw. I would like some opinon on wether the mechanical release does damage the bow string or is its worth having that extra draw length and not use a loop.
One more thing. Is there any special concerns that I should be aware of when changing bow string and cable with the use of a bow press?

Thanks in advance for any information or opinons that you may have.

[WOOKIE]

In my opinion, string loops are the way to go. As well as being able to custom tune your draw length, it eliminates all torque on the bowstring and the pull is directly behind the nock, not under it. String loops are a huge benefit. As for changing out a string, make sure you know how to use the press. Press the riser directly over the limb pockets to avoid bending the riser, and before you remove the string, have a good look at routing or better yet, take a couple of pictures, so you can install the new string in the proper manner.

Good Luck

[RodS]

Although I currently am not using a loop, I do prefer them for the same reasons that cdnarcher said. To answer your other question is yes mechanical release aids chew up the serving on your bowstring and will break it. As for pressing your bow, again cdnarcher has that covered as well.

[scooter]

Although I currently am not using a loop, I do prefer them for the same reasons that cdnarcher said. To answer your other question is yes mechanical release aids chew up the serving on your bowstring and will break it. As for pressing your bow, again cdnarcher has that covered as well.

Yup, cdnarcher is right. (did I just say that?) ummm...I mean what RodS said. :lol:

[littleal]

Another thing you may want keep in mind, particularily if you shoot a short ATA bow would be Nock pinch.

I shot off the string for years. When I purchased my recent bow, it was required to use a loop.
AL

[sledder]

I sure appriciate all the info, thanks alot. I used the blueprint from the section "projects to build" to build a bow press and it works great.

:-) Again, thanks for all the great information on the forums,

Sledder

[grandpawrichard]

Here's a worthwhile article by Bob Ragsdale (Terry Ragsdale is a retired World Champion archer, his Dad taught him everything he knows):

Here's some information about the string Loop. It was written by Terry Ragsdale's Dad. As you will soon see, the minor irritations of peep alignment (due to string stretch and settling in....not due to the string loop) and the absolutely Minimum (if any) loss of speed are very much out weighed!

Here are Bob Ragsdale’s reasons to use a string loop:
"Eliminates arrow-falloff at full draw.
- Makes nocking point location less critical.
- No need to re-nock after a let-down.
- No serving wear from release aid contact.
- Assures easy one-hand loading
- Releases can remain attached and ready to go.
- Eliminates gaps in serving from up pressure on nocking point.
- Controls peep sight rotation.
- Eliminates nock warping due to pinch at full draw.
- Allows release aids to be at an angle rather than only level.
- Makes shorter length bows easier to work with.
- Extends maximum available sight range area.
- Prevents arrow from sliding down the string during the shot.
- Prevents release aid rope slap with high cheek anchor.
- Improves shoulder alignment.
- Loop length can modify draw length of bow.
- Eliminates chin slap from inward swinging release aid ropes.
- Can be used with all non-rope release aids.
- Reduces string vibration noise."

I hope it helps you!

Dick